Restarting a Logger

Here's a simple guide to restarting your SUMS Logger:
Written by Ollie Chapman
Updated 3 weeks ago

Step-by-Step Instructions:

Locate the "Magnet" Spot:

On your SUMS Logger, you'll find a specific area marked with the word "Magnet."

Apply the Magnet:

Hold a magnet firmly against the "Magnet" spot on the logger.

Ensure the magnet is in direct contact with the designated area.

Keep the magnet in place for a full 10 seconds.

Verify Power Off:

Once the 10 seconds are up the lights will flash in a sequence, when the lights no longer flash, this indicates that the device has powered down.

Restart the Logger:

Gently swipe the magnet across the "Magnet" spot again.

Wait a few moments for the lights to turn back on. This signifies a successful restart.

Did this answer your question?